top of page
FireDuct4seitig.png
JamesHardieAMCF.png

FireDuct

Installation shaft EI 90 / fire protection wall

The FireDuct installation shaft consists of self-supporting, mutually rebated elements made of glass fiber reinforced lightweight concrete - fire protection panels.


Thanks to this construction, a homogeneous, extremely slim and stable wall construction with a wall thickness of only 50mm is achieved, which therefore requires no further additional substructures.


After the usual pre-treatment, the installation shaft walls can be painted, plastered or covered with ceramic tiles.

EI 90

1000x1250mm

50mm

fire resistance
Maximum shaft dimensions
plate thickness
Image by C Dustin

FireDuct product benefits

  • Thin construction (50mm)

  • Short installation times

  • Made to order from the factory

  • EI 90 - fire resistance

  • Solid & Stable

  • 1-, 2-, 3-, or 4-sided design

  • Moisture and water resistant

  • Ecological construction

FireDuct-Installationsschacht.png

FireDuct fire protection wall

The FireDuct partition wall construction for shaft walls can be manufactured with a fire resistance of 30 to 120 minutes. Aestuver fire protection panels are used for the FireDuct fire protection walls, which can also be used in highly humid and climatically stressed areas. With the use of FireDuct fire protection walls, the highest fire protection requirements can be combined with visually appealing design. The FireDuct fire protection walls are mainly used in fire protection-performing dry construction systems in interior areas, where high sound insulation requirements must be met at the same time.

FireDuct-1seitig.png

FireDuct shaft wall

  • Unlimited wall length

  • Wall construction possible without substructure

  • Can be used outdoors without additional coating

  • Room-high panels enable fast, time-saving processing

  • Further construction with substructure and larger wall heights possible

  • No insulation required

  • Wall height up to 4'000mm

  • EI 30 - EI 120

FireDuct shaft walls can be built in front of solid components (masonry or concrete, which have the required fire protection and are permanently heat-resistant) or in corners made of solid components (room corner or ceiling/wall connection), the sides of the shaft may be formed by solid components.

Contact us!

Thank you for your message! We will contact you as soon as possible!

bottom of page